House Improvement: 8 Steps to a Great Travertine Backsplash

Kitchen Renovation

The most satisfying thing for a homeowner is to put in some sweat equity in his home and enhance the worth of his possession (or liability in today's economic condition).

I recently had the experience of installing travertine tile in my kitchen and it turned out great.

This was the first huge project carried out by me and my wife since we got our house just about 3 years earlier. We went through a lot of back and forth in between getting the tiled set up by an expert vs doing it ourselves.

In the end we chose, that it would be best if we undertook the task ourselves as there was quite some money to be saved. We were estimated from anything from 7 prevented to twelve hundred simply for the setting up the tile.

Here are the actions we required to reach our goal:

Coordinate with a tile designer to come up with a pattern for the kitchen area tiles. We took precise measurements of all the walls that needed to be tiled and drew it out on a paper to scale. This was followed by drawing the tiles on the paper and making a pattern.


After the standard pattern of the tile is chosen, we picked out accent tiles to go at specific area to make the entire thing pop.

After the final pattern was designed, we determined the amount of cement, grout and tile needed for the job. The tile designer helped us in the phase in the evaluation, but in the end after accomplishing the job, we had almost one box of tile left.
Scrubbed all the walls and developed gouges on the walls for the tile cement to bond. This was followed by cleaning up the surface areas thoroughly and permitting it to dry.

We eliminated all residue from the walls guaranteeing that the surfaces were even with no ridges.

We started the tiling by positioning the accent pieces initially on the walls. This is a really essential action in tile style as the accent pieces stand out and have to be exactly where you plan them to be. The basic tile can be cut when we reach the edge of the wall and will not be noticeable.
After laying down the accent pieces, we continued to cut and put the regular tile around these and finish all the walls. Ensure that even spacing is supplied in between tiles for the very best possible appearance.

After the tile is put down, we put a finishing for sealant on the entire tiled surface. As we were dealing with travertine tile and wished to keep the perforated appearance of the tile, this action was compulsory.

Once the sealant has cured, we proceeded to grout the tile, making sure we don't fill out the holes of the tile with the grout. The grout lines were kept to a minimum so make sure we do not smudge the entire tile.

One the grout dried, we utilized a brush to eliminate excess grout, cleaned the tiles and sealed once again.

After about 2 weeks, we sealed the tiles once again and caulked the tiles to finish the task. In the end, the task was very successful and we wound up conserving a lot of cash by doing it ourselves.

their website The most essential thing we gained from the tiling process was to keep the grout lines to a minimum and maintain the natural appearance of the tile. Now, the tiling task is comparable to the most costly tiller's installation. I strongly motivate everyone to do these themselves as it is a really straightforward procedure.

Leave a Reply

Your email address will not be published. Required fields are marked *